Installation Guide

Connect the RF Module Cables
FlexWave Prism RF Modules for Prism Remote Units Installation Guide Page 37
TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013 © 2013 TE Connectivity Ltd.
LatchesonDual‐Slot40WRFModules
ForDual‐Slot40WRFModules,securefourlatches,asshowninFigure20.
Figure20.Dual-Slot 40W RF Module Latches
VerifythattheRFModuleMountingHookisEngaged
1 VerifythattheRFModuleMountingHookisengagedcorrectlybypullingthemoduleaway
fromtheheatsink.TheRFModuleshouldnotmove.IftheRFModulemovesduringthischeck,
repeatallthestepsstartingat
“InstalltheRFModuleintothePrismRemoteChassis”on
page26throughthisstep.
ConnecttheRFModuleCables
ThestepstoconnecttheRFModulecableshavebeenseparatedintotwodifferentprocedures;
followthestepsthatcorrespondtotheRFModulebeinginstalled.
• “ConnectingCablesinaSingle‐SlotRFModuleInstallation”onpage38
• “ConnectingCablesinaDual‐SlotRFModuleInstallation”onpage40.
Four latches in
a Dual-Slot 40W
RF Module