Installation Guide
Table Of Contents
- Preface
- Overview of RF Modules for PRUs
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
Install the RF Module into the Prism Remote Chassis
FlexWave Prism RF Modules for Prism Remote Units Installation Guide Page 27
TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013 © 2013 TE Connectivity Ltd.
Figure11.Installing a Single-Slot RF Module
RF MOD C
RF MOD D
SeRF
Module
RF MOD A
RF MOD B
Single-Slot
RF Module
Heat Sink