Installation Guide

Table Of Contents

Install the RF Module(s)

Page 26 FlexWave Prism RF Modules for Prism Remote Units Installation Guide

InstalltheRFModuleintothePrismRemoteChassis

Recommendation: InstallDual‐BayDual‐Slotmodulesinthetwoupper‐mostslotsofthePRU.

Recommendation: InstallDual‐Slot40Wmodulesinthebottom‐mostslotsofthePRU.

Recommendation: IfbothaDual‐SlotAWS210040WRFModuleandaDual‐SlotPCS190040W

RFModuleareinstalledinaQuad‐BayPRU,installtheAWS2100Modulein

thelower‐mostslotofthePRU.

1 HoldtheRFModulesothattheDARTcard(s)faceawayfromthePRUandtheMountingHook

istowardtheReceivingflangeonthePRUchassis.

NOTE: AlwaysinstallRFModulesfromthebottomup.Donotskipaslot.

2 HoldingtheRFModuleata45°angleinrespecttotherearheatsink,restthebottomsurface

ofthemoduleontheRFModuleshelf,asshowninoneofthefollowinggraphics,andas

applicabletotheRFModule.

• Single‐SlotRFModule:Figure11onpage27

• HDMRFModule:Figure12onpage28

• Dual‐BayDual‐SlotRFModule:Figure13onPage29

• Dual‐Slot40WRFModule:Figure14onPage30.