Installation Guide

Dual-Slot Modules Only—Remove the Module Slot Shelf
FlexWave Prism RF Modules for Prism Remote Units Installation Guide Page 25
TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013 © 2013 TE Connectivity Ltd.
Dual‐SlotModulesOnly—RemovetheModuleSlotShelf
1 ForDual‐SlotRFModulesonly.
IfyouareinstallingaDual‐Slot
RFModule,youmustremovea
moduleslotshelffromthePRU
chassistoaccommodatethe
module’ssize.(Forfurther
information,see
Table7on
page16.)
Removetheshelfasappropriate
fortheRFModule:
• ForaDual‐Slot40WRF
Module,removetheModule
BShelf.
• ForaDual‐BayDual‐SlotRF
Module,removeModuleD
Shelf.
Toremovethemoduleshelf:
a Usea9/64”Allen
™
wrench
toremovethethreescrews
thatattachthemoduleshelf
tothePRUchassis,asshown
inthefollowinggraphic.
b Discardorstorethemodule
shelfandfasteners.
Use 9/64” Allen Wrench to
remove the three module-shelf screws
Remove Module D Shelf for
Dual-Band Dual-Slot RF Modules
Remove Module B Shelf for
Dual-Slot 40W RF Modules