Installation Guide
Table Of Contents
- Preface
- Overview of RF Modules for PRUs
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
Overview of RF Modules for PRUs
Page 10 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2013 TE Connectivity Ltd TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013
PrismRemoteUnitDual‐Slot40WRFModules
TheFlexWavePRUDual‐Slot40WRFModule(Figure5)isdesignedforAWSandPCSfrequencies.
ThePrismRemote40WRFModulecomprises:
• oneDART
• twoPowerAmplifiers(PAs)
• oneRemoteDARTInterface(RDI)board.
NOTE: ThismanualdescribeshowtoinstallthePCS1900andAWS2100Non‐DiversityRFModules.
Figure4.Dual-Slot 40W RF Module
SupportedRFModules
Table4. FlexWavePrismRFModulesforPRUsSupportedinthisInstallationGuide
Catalog Number Description
FWP-4210000MOD 6.5W 800 SMR MODULE, NON-DIVERSITY, CLASSIC
FWP-6216000MOD 10W, EGSM 900, NON-DIVERSITY, SGL SD
FWP-6226000MOD 10W, EGSM 900, DIVERSITY, SGL SD
FWP-7416000MOD 20W, GSM 1800, NON-DIVERSITY, SGL SD
FWP-741S000MOD 20W, GSM 1800, NON-DIVERSITY, DL SD
FWP-7426000MOD 20W, GSM 1800, DIVERSITY, SGL SD