Installation Guide

Table Of Contents

PRU RF Module Types

FlexWave Prism RF Modules for Prism Remote Units Installation Guide Page 9

PrismRemoteUnitHDMRFModules

PRUHDMRFModules(Figure3)aredesignedfor850Cellfrequencies.Theinitialreleaseofthe

HDMRFModuleisaSingleInputSingleOutput(SISO)Configurationthat

• interfacesoneHostDART—eitherClassicorSuperDART

• supportstwonon‐contiguousRFslicesupto25MHztotalbandwidth—SuperDARTonly

• supportsupto40WRFoutputpower.

Figure3.HDM RF Module

ThecomponentsofaPRUHDMRFModulearedependentonthemoduletype,aslistedinTable3.

Table3. ComponentsofPRUHDMRFModules

RF Module Type DPM LPA Duplexer Rx Card Tx Card

SISO

(1)

1 1 1 1 1

MIMO/Dual Band Module

(2)

1 2 2 2 2

(1) 850 20W and 40W only.

(2) 700 MIMO 20W and 850/1900 20W only.