Installation Guide
Table Of Contents
- Preface
- Overview of RF Modules for PRUs
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Slot Modules Only—Remove the Module Slot Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Contacting TE Connectivity
Overview of RF Modules for PRUs
Page 8 FlexWave Prism RF Modules for Prism Remote Units Installation Guide
© 2013 TE Connectivity Ltd TECP-77-141 Issue 5 • 300001744178 Rev E • November 2013
PrismRemoteUnitSingle‐andDual‐CardRFModules
Figure2showsexamplesofPRUSingle‐andDual‐SlotRFModules,bothofwhichhavetwo
DARTs.APRUSingle‐andDual‐CardRFModulecomprise:
• oneDART
• oneDuplexerwithoneortwointernalLowNoiseAmplifiers(LNAs)
• oneLinearPowerAmplifier(LPA)
• oneRemoteDARTInterface(RDI)board.
Figure2.Single- and Dual-Slot RF Modules
Dual-Band Dual-Slot RF Module
Single-Slot Dual-Card RF Module