Installation Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
Page6 FlexWavePrismRemoteUnitRFModuleInstallationGuide
©2014TEConnectivity TECP‐77‐141Issue6 • 300001744178RevF • July2014
OVERVIEWOFRFMODULESFORPRISMREMOTEUNITS
Figure1illustratesthePrismRemoteUnit(PRU),whichcontrolsRFemissions,interfaceswiththeFlexWave
PrismHostUnit.
Single-Bay
Prism Remote Unit
Dual-Bay
Prism Remote Unit
Tri-Bay
Prism Remote Unit
Quad-Bay
Prism Remote Unit
Figure1.PrismRemoteUnits(PRUs)
ThePRUhasfromonetofourRFModulebays,dependingonthePR
Umodel.Thatis,theSingle‐BayPRUhasone
RFModulebay,andtheQuad‐BayPRUhasfourRFModulebays.APRUcansupportuptofourRFModules.
ThefunctionofthePRURFModuleson
theForwardPathisto:
• convertthedigitizedRFtransportedfr
omtheHosttoAnalogRF
• a
mplifytheAnalogRFsignal
• providesignalfiltering.
ThefunctionofthePRURFModulesontheReversePathisto:
• conv
erttheAnalogRFfromthehandsettoDigitalRFfortransporttotheHost
• providesignalfiltering.
NOT
E: TheRFModulesarefieldreplaceable,butcannotbeservicedinthefield.