Installation Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- FlexWave Notch Filter (FWP-SPRINTFILTER)
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
Page10 FlexWavePrismRemoteUnitRFModuleInstallationGuide
©2014TEConnectivity TECP‐77‐141Issue6 • 300001744178RevF • July2014
LegacyDual‐Bay40WRFModules
TheLegacyDual‐Bay40WRFModule(Figure5)isdesignedforAWSandPCSfrequenciesandissupportedonly
byClassicDARTs.TheLegacyDual‐Bay40WRFModulecomprises:
• oneClassic
DART
• on
eDuplexer
• twoPowerAmplifiers(PAs)
• oneRemoteDARTInterface(RDI)board.
NOTE: ThismanualdescribeshowtoinstallthePCS1900andAWS2100Non‐DiversityRFModules.
Figure4.Leg
acyDual‐Bay40WRFModule