User's Manual

Manage Alarms
Page 174 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
3 To remove the filter:
a In the View list, select None.
b Delete any text from the contains box.
c Click Filter.
MANAGE ALARMS
To access the Manage Alarms page, in the System Menu bar, click Alarms > Manage
Alarms.
• For an example of a Manage Alarms page for a Host Unit, see Figure 23 on
page 175 and Figure 24 on page 176.
• For an example of a Manage Alarms page for a Remote Unit, see Figure 25 on
page 177 and Figure 26 on page 178.
The Manage Alarms page has the following elements:
• Select menu—has the following implementations:
– Global—displays alarms for the Host and all connected Remote Units. Please
note, however, that this view does not reflect the current status of alarm
enable/disable conditions—it is designed to show you at a glance those
alarms that can be managed. To effect a change in the management of an
alarm and to see the current state of an alarm, select a specific unit.
– Unit name—each unit in the system is listed by name, which allows you to
select for which unit you want to manage alarms.
• Antenna Disconnect Severity menu—see “Antenna Disconnect Alarm” on page 181.
• Unit field—what type of unit the alarm pertains to:
– Host
– Remote
• Module field—which module the alarm pertains to:
– DART—can be up to eight DARTs listed
– LNA—can be up to two LNAs listed
– Power Detector
– SFP—can be up to eight SFPs listed
– SeRF
• Alarm Name field—identifies the alarm by name; see Table 23 on page 178.
NOTE: For definitions of the alarms listed above, see “Troubleshooting Alarms” on page 185.
• Enabled selection box—select to enable alarm reporting for the corresponding
alarm.
• Threshold Value field—value that once surpassed generates the specified alarm;
see
Table 23 on page 178.