User's Manual

Set the Capacity for a New Remote Unit RSI Board
Page 162 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
If the DART has been removed from the Host or PRU/URU chassis, then the
entire DART entry disappears. If the DART is still present in the Host or
PRU/URU chassis, then the DART Name and Passband is reset to default.
SET THE CAPACITY FOR A NEW REMOTE UNIT RSI BOARD
The Capacity setting in the Edit Properties page pertains to the PRU/URU Remote SeRF
Interface (RSI) board and the number of RF groups available to the Remote Unit.
This parameter is set during manufacturing and should be changed only when the
RSI board has been replaced.
Using the EMS GUI to Change the Remote Unit Capacity
The Capacity setting can be changed by logging onto the EMS through the Remote
Craft port.
1 Open the unit and connect your laptop to the Craft port on the SeRF.
2 Login to the EMS, using the following parameters:
• IP address is 192.168.0.1
• User Name is operator
• Password is operator