User's Manual

Managing Units

FlexWave Prism Element Management System 7.1 User Manual Page 153

• Tx Byte Counter—Transmit byte counter that increments by the number of bytes

that were put on the wire including fragments of frames that were involved

with collisions. This count does not include preamble/SFD or jam bytes. This

counter does not count if the frame is truncated.

• Tx Pkt Counter—Transmit packet counter that increments for each transmitted

packet (including bad packets, excessive deferred packets, excessive collision

packets, late collision packets, all unicast, broadcast, and multicast packets).

• Tx Broadcast Pkts—Transmit broadcast packet counter that increments for each

broadcast frame transmitted (excluding multicast frames).

• Tx Multicast Pkts—Transmit multicast packet counter that increments for each

multicast valid frame transmitted (excluding broadcast frames).

• Reset Counter button—click to clear the statistics in the Network Statistics page.

EDITING UNIT PROPERTIES

Unit properties are set during initial setup, but can be changed at any time. See

one of the following:

• “Configure Basic Host Unit Properties” on page 64

• “Label the PRU/URU” on page 66.

CONFIGURING OPTICAL PORTS

Optical port configurations are set during initial setup, but can be changed at any

time. See one of the following:

• See “Label the Host Optical Ports” on page 67.

• See “Label PRU/URU Optical Ports” on page 70.