User's Manual

System Management
FlexWave Prism Element Management System 7.1 User Manual Page 123
ADCP-77-177 • Issue 1 • July 2011 © 2011 ADC Telecommunications, Inc.
EDIT THE PROPERTIES OF ALL UNITS IN THE SYSTEM
The Edit Unit Properties page that is accessible through the System Menu bar allows
you to edit basic information and optionally provide notes for all the units in the
system at one time.
To access the Edit Unit Properties page, in the System Menu bar, click System
Configuration > Edit Unit Properties.
The Edit Unit Properties page has the following elements, where each row in the Edit
Unit Properties table correspond to the unit identified in the Unit Id column.
• Unit Id column—identifies the unit within the system; see “Unit Identification”
on page 43.
• Unit Name column—provides a text box that allows you to enter a unique name
for the Host and each connected Remote. Each Unit Name must start with an
alphabetical character, be between 5 and 40 characters (alphanumeric or
underscore only), and contain no spaces.
• IP Address column—the IP address of the unit
NOTE: An IP address of the type 169.254.x.y will only be communicable if the connected laptop also has
a 169.254.x.y address.
• Contact Alarms column—identifies active contact alarms, if any. For information
on contact alarms, see any of the following:
– “Contact Alarms—Host System Card” on page 201
– “Contact Alarms—Remote Unit” on page 201
• Notes column—provides a text box that allows you to enter notes specific to the
unit. You can enter up to 256 characters; all keyboard characters can be used.