User's Manual

Moving or Reconfiguring Fibers
Page 122 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
MOVING OR RECONFIGURING FIBERS
If you need to move or reconfigure fibers during troubleshooting, follow the steps
below.
1 Move Host SFPs and fibers to their new locations.
2 Do the following if a previously filled SFP position is now empty:
a There will still be a GUI representation of a Remote on that SFP. To remove
this ghost representation, follow the steps in
“Clear All Disconnect Alarms”
on page 184.
b To delete fiber and SFP alarms attributed to the abandoned SFP positions,
follow the steps in
“Clear Current Alarms” on page 170.
3 Complete this step only for moved DARTs now in an alarmed state. If
the configuration of a Remote Unit DART originally connected to an SFP does
not match the configuration of the DART moved to the SFP, the new DART will
have an alarm state such as Module Missing Fault or DART Hardware Mismatch. In this
instance, follow the steps in
“Clearing DART Configurations” on page 161 to
clear the configuration of the DART in the alarmed state.