User's Manual

Special Features

FlexWave Prism Element Management System 7.1 User Manual Page 227

CONFIGURE FEATURE

CAUTION! This procedure requires a system reboot. The system configuration is stored on the Host.

Rebooting the Host therefore results in a loss of RF for the Host and connected Remote

Units until the Host comes back up. Depending on the system configuration, it can take 5

to 20 minutes before management communication is restored.

CAUTION! Host configuration will not persist across a Configure Feature Reboot—all settings will

revert to factory default. You will need to reconfigure the Prism system after the system

reboots.

CAUTION! The current EMS session will close and you will need to log back in to the EMS after the

Host reboot has completed.

1 Document all configuration data, as settings will have to be re-entered. To

record the current configuration:

a Follow the procedures in “Viewing the All Report” on page 112 to access the

system configuration reports.

b Follow the procedures in “Downloading a Report” on page 113 to download

the system configuration reports to a hard drive.

2 To access the Configure Feature page, in the System Menu bar, click Special Features

> Configure Feature.

3 In the Feature box, enter the

code for the feature.

4 In the Password box, enter the

password that enables the

feature.

5 Click Apply.

6 In the confirmation dialog, click OK.

7 Log back in to the EMS once the login window displays.

8 Follow the steps in “Initial FlexWave Prism System Setup” on page 55 to

reconfigure the Prism system, using the settings recorded in Step 1 on

page 227.