User's Manual

Updating Individual Units
Page 222 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
4 In the Unit Menu bar, click Unit Upgrades, Upgrade.
NOTE: If you have not uploaded the required update files, the following page opens, and the
Update button is disabled. You cannot continue until the correct update files have been
loaded.
5 Click Update.
Within four minutes, the EMS logs you off and terminates the EMS session.
CAUTION! At this point, the system goes offline for the approximate time listed in Table 25 on
page 216.
6 Wait approximately four minutes, and then log back in to the EMS to complete
this procedure.
7 Complete Step 1 on page 216 to verify the status of the update. Do not move
forward to the next step until the UpGrade Status in the Software/Firmware table
is listed as Upgraded.