User's Manual

Page 296 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
7 Select the LNA # to read or program:
8 Select the desired Duplexer type (1-21) or 0 to read the current Duplexer type:
9 Once the Duplexer has been programmed, verify the correct Duplexer type by
performing a read of the LNA as well as checking the Duplexer type shown in
the RF Groups in the GUI.
10 Repeat for all Duplexers needing programming.
LNA URU Position PRU Position
1 Right Door, DART 1 Module A, DART 1
2 Right Door, DART 2 Module A, DART 2
3 Front Door, DART 3 Module B, DART 3
4 Front Door, DART 4 Module B, DART 4
5 Left Door, DART 5 Module C, DART 5
6 Left Door, DART 6 Module C, DART 6
7 n/a Module D, DART 7
8 n/a Module D, DART 8
Select: …for this Duplexer Type
1 850 Cellular A\+A+A'
2 850 Cellular B+B'
3 800 APAC iDEN (shipped)
4 1900 PCS
5 800 SMR Low Wide URH
6 1800 GSM
7 900 EGSM
8 900 EGSM P-GSM
9 700 Upper C
10 800 SMR Prism Paired with 900 SMR
11 900 SMR Prism Paired with 800 SMR
12 800 SMR Prism Unpaired
13 850 APAC
14 800 SMR Low URH
15 900 SMR High URH
16 2100 AWS
17 850 Cellular A\+A+B+A'+B'
18 2100 UMTS
19 900 EGSM APAC
20 700 Lower ABC
21 800 APAC iDEN (spec)
0 read type from EEPROM