User's Manual

Get Information
Page 108 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
Viewing the Host RF Report
To access the Host Forward Gain Settings report, in the System Menu bar, click System
Information > Get Information, and then in the Reports panel Type list, select Host RF.
The Host Forward Gain Settings table provides the following information.
• DART Id—number of the Host slot in which the DART is installed
• DART Name—user-defined name for the Host DART
• DART Mode—identifies the RF function
– Standby—RF function is muted in the Host and its linked Remote Unit.
– Normal—RF function not forced to be muted, allows the system to operate
normally
• Fwd Gain (db)—Forward Gain in decibels assigned to the DART
• Power Level Mode—Host DART Input Power Level Mode:
– Snapshot—provides a “snap-shot” or current RF measurement for the
selected Remote DART (default setting).
– Max Hold—retains the maximum values for peak and peak average, and the
minimum values for minimum average since the last Max Hold Reset.
NOTE: The Power Level Mode is disabled if the:
• DART Operating mode is set to Standby
• DART Pass Band (Timeslots) parameter is set to Undefined (default)
• DART Diversity Status is set to Diversity.
• Peak Power (dBm)—highest level of power experienced on the DART Forward link.
• Average Power (dBm)—average power experienced on the DART Forward link.
• Minimum Power (dBm)—average minimum power experienced on the DART
Forward link.
• Last Max Hold Reset Time—time that Max Hold was last reset.
• Passband—type of passband provided by the DART.
• Frequency (MHz)—passband frequency of the DART