User's Manual

System Information
FlexWave Prism Element Management System 7.1 User Manual Page 107
ADCP-77-177 • Issue 1 • July 2011 © 2011 ADC Telecommunications, Inc.
Viewing the Fiber Report
To access the Fiber Optics report, in the System Menu bar, click System Information >
Get Information, and then in the Reports panel Type list, select Fiber.
The Fiber Optics table provides the following information:
• Unit Type—what the unit is, such as Host or Remote.
• Unit Name—Unit ID of the unit based upon layered address; see “Unit
Identification” on page 43.
• SFP Number—Optical port number, from 1 to 8.
• SFP Name—name assigned to the Optical port; default SFP Name is
UNKNOWN_SFPNAME.
• Optics Type
– LongRange—26 dB
– IntermediateRange—18 dB).
• Wavelength (nm)—wave length transmitted through this port:
– Non-duplex and WDM configurations: 1550 nm fwd, 1310 nm rev
– CWDM configurations can be one of eight wavelengths: 1470 nm, 1490 nm,
1510 nm, 1530 nm, 1550 nm, 1570 nm, 1590 nm, and 1610 nm.
• Tx Power (dBm)—launch power level in dBm of forward path signal. The minimum
FWD launch power is -2 dBm, and the maximum is 3 dBm.
• Rx Power (dBm)—receive power level in dBm of reverse path signal, which
incorporates the launch power of the Remote Unit SFP plus all optical losses
(insertion losses, fiber cable loss, and so forth).
• Remote Name—name of the Remote connected to this Optical port.
• Alarm Status—whether an alarm is active. If an alarm is active, there will be a
Minor or Major link that you click to open a dialog that defines the active alarm,
as described in
“Viewing Alarm Details” on page 45. The background color of
the Alarm Status cell also indicates the alarm level (see “Alarm Color Codes” on
page 44).