User's Manual

Initial FlexWave Prism System Setup
FlexWave Prism Element Management System 7.1 User Manual Page 95
ADCP-77-177 • Issue 1 • July 2011 © 2011 ADC Telecommunications, Inc.
5 In the Power Level Mode list, select one of the following:
• Snapshot—provides a “snap-shot” or current RF measurement for the
selected Remote Unit DART (default setting).
• Max Hold—retains the maximum values for peak and peak average, and the
minimum values for minimum average since the last Max Hold Reset.
Power Level Mode is disabled under any of the following conditions:
• if the DART Operating mode is set to Standby
• if the DART Pass Band (Timeslots) parameter is set to Undefined (default)
6 Click Apply.