User's Manual

Initial FlexWave Prism System Setup

FlexWave Prism Element Management System 7.1 User Manual Page 87

f If you set the Power Level Mode to Max Hold, you can click Reset Max Hold to reset

the Max Hold values. The Host Forward Gain Settings table updates with the new

settings.

The Host Parameters table provides the following information:

• Peak Power (dBm)—shows the highest (peak) power level reached by the

Host DART

• Average Power (dBm)—shows the average power level reached by the Host

DART

• Minimum Power (dBm)—shows the minimum power level reached by the

Host DART

g Click Apply.

• Once the system executes the command, an Operation completed message

displays.

• The Host Forward Gain Settings table at the bottom of the page is updated

with the new settings.

h Repeat Step b on page 86 through Step g for each Host DART.

For information on the Host Forward Gain Settings table, see “Viewing the Host RF

Report” on page 108.