User's Manual

Configure Host Forward Gain
Page 86 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
2 In the EMS, do the following to set the Host Forward Gain parameters:
a To access the Configure Host Forward Gain page, in the System Menu bar, click
System Configuration > Configure Host Forward Gain.
b In the Host Parameters table DART list, select the Host DART that you want to
configure. Other information in the Host Parameters table is updated to show
settings for the selected DART.
c In the DART Mode list, select one of the following:
• Standby—forces the RF function to be muted in the Host and its linked
Remote Unit.
• Normal—allows the system to operate normally (RF function not forced to
be muted), assuming all other system components are in proper working
order. (Default setting.)
d In the Fwd Gain (dB) list, select the Forward Gain value of 0 to 31 dB, based
upon the fully loaded forward path signal level from the Base Station.
e In the Power Level Mode list, select one of the following:
• Snapshot—provides a “snap-shot” or current RF measurement for the
selected Remote Unit DART (default setting).
• Max Hold—retains the maximum values for peak and peak average, and
the minimum values for minimum average since the last Max Hold Reset.
NOTE: The Power Level Mode is disabled if the:
• DART Operating mode is set to Standby
• DART Pass Band (Timeslots) parameter is set to Undefined (default)
• DART Diversity Status is set to Diversity.