User's Manual

Initial FlexWave Prism System Setup
FlexWave Prism Element Management System 7.1 User Manual Page 83
ADCP-77-177 • Issue 1 • July 2011 © 2011 ADC Telecommunications, Inc.
3 Click Apply. The Operation complete message displays, and the Remote Parameters
table clears so you can set the delay for another DART.
4 Repeat Step 2 through Step 3 for each DART.
Using the Linked DARTs Delay Table
The Linked DARTs Delay table provides the following information:
• Host columns—identifies the Host in the link
– DART Id—number of the Host slot in which the DART is installed
– DART Name—user-defined name for the Host DART
• Remote columns—identifies the Remote and its elements
– Id—Unit ID of PRU/URU based upon layered address; see “Unit
Identification” on page 43
– Name—user-defined label for the PRU/URU
– DART Id—PRU/URU slot number in which the DART is installed
– DART Name—user-defined name for the Remote DART
– Forward Delay (s)—user requested FWD RF path delay in microseconds
– Reverse Delay (s)—user requested REV RF path delay in microseconds
• Common columns—configuration settings common to the Host and Remote(s)
– Passband—type of passband provided by the DART.
– Frequency (MHz)—passband frequency of the DART