User's Manual

Configure DART Links
Page 72 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
2 In the Host Parameters panel, set the following parameters:
a In the DART list, select the Host DART that you want to link to the Remote
Unit DART.
b In the DART Name box, enter a name for the DART, which must start with an
alphabetical character, contain between 5 and 32 characters (alphanumeric
or underscore only), and contain no spaces.
c Use the Passband column to set the passband for the selected DART.
• If you are configuring a Classic DART, then refer to the passband
selection table in the corresponding section:
 “800 APAC iDEN Classic DART” on page 75
 “800 SMR Classic DART” on page 75
 “900 SMR Classic” on page 76
 “2100 AWS Classic DART” on page 76
 “Cellular Classic DART” on page 77
 “PCS Classic DART” on page 77
The following figure shows the passband selections for the 2100 AWS
Classic DART, which are described in
“2100 AWS Classic DART” on
page 76.