User's Manual

Label the Host Optical Ports
Page 68 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
3 In the SFP Name box, enter a label for the selected Optics port. The SFP Name
must start with an alphabetical character, contain 5 to 32 characters
(alphanumeric or underscore only), and contain no spaces. The default SFP
Name is UNKNOWN_SFPNAME.
4 Click Apply. Once the system executes the command, an Operation completed
message displays.
The Configure Optical Ports table provides the following information.
• SFP Number—system assigned number (from 1 to 8) for the Optical ports
• SFP Name—see Step 3 on page 68.
• In/Out—used for cascading, which is not supported in this release. The Host will
therefore always be set as Out (indicates that the forward link for the connected
SFP is going away from the Host) and the SFPs for all Remote Units will always
be set as In.
• Optics Type
– LongRange—26 dB
– IntermediateRange—18 dB)
• Wavelength (nm)—number displayed is the wavelength transmitted through this
port:
– Non-duplex and WDM configurations
 1550 nm fwd
 1310 nm rev
– CWDM configurations can be one of eight wavelengths:
 1470 nm  1550 nm
 1490 nm  1570 nm
 1510 nm  1590 nm
 1530 nm  1610 nm