User's Manual

Prism System Overview
FlexWave Prism Element Management System 7.1 User Manual Page 27
ADCP-77-177 • Issue 1 • July 2011 © 2011 ADC Telecommunications, Inc.
Host DART Slots
Figure 13 shows the possible slot assignments for Single and Dual SuperDARTs,
and where slot-divider bars are located.
Figure 13. DART Slot Assignments in Host Chassis
Possible slot assignments for Single and Dual SuperDARTs are listed below.
• A Classic DART or Single SuperDART can be installed in each of the eight slots
in the Host.
• Single-Slot SuperDARTs plugged into slots 1 or 3 of a Host that has both a SeRF
II Module and a Backplane II chassis installed can pass 12 fiber slots like a
dual-slot SuperDART.
• Dual SuperDARTs require that slot divider bars be removed as their size
requires two-slot combinations, which are available in the following vertical
groupings:
–Slots 1 and 3
–Slots 2 and 4
–Slots 5 and 7
–Slots 6 and 8.
• Dual SuperDARTs cannot occupy horizontal slot combinations:
–Slots 3 and 5
–Slots 4 and 6.
• Any combination of DARTs may be installed.
SeRF Card
System Card
Power Supply
Single-Slot DART
in Slot 1
Single-Slot DART
in Slot 3
Single-Slot DART
in Slot 2
Single-Slot DART
in Slot 4
Single-Slot DART
in Slot 7
Single-Slot DART
in Slot 5
Single-Slot DART
in Slot 8
Single-Slot DART
in Slot 6
Fan Assembly
Divider bars between
Slots 1 and 3
and Slots 2 and 4
Divider bars between
Slots 5 and 7
and Slots 6 and 8
SeRF Card
System Card
Power Supply
Fan Assembly
77073-077
Dual-Slot DART
in Slots 1 and 3
Dual-Slot DART
in Slots 2 and 4
Single-Slot DART
in Slot 7
Single-Slot DART
in Slot 5
Single-Slot DART
in Slot 8
Single-Slot DART
in Slot 6
Divider bars between
Slots 1 and 3 and
Slots 2 and 4 removed
to accommodate
Dual-Slot DARTs