User's Manual

Prism System Overview
FlexWave Prism Element Management System 7.1 User Manual Page 13
ADCP-77-177 • Issue 1 • July 2011 © 2011 ADC Telecommunications, Inc.
SeRF II Module LEDs
Ref # LED LED Color Description
1
SFP TX •OFF
• GREEN
•RED
• No Small Form-Factor Pluggable (SFP) present
• SFP is present and the FPGA internal Phase-Locked Loop (PLL) is locked
• SFP is present and the FPGA internal PLL is not locked
SFP RX •OFF
• GREEN
•AMBER
•RED
• No SFP present
• Receiver has locked and framed to the incoming signal
• Receiver has light, but is not locked to the incoming frequency or not framed
• Receiver has no light
2 ALARM
• GREEN • No major alarm is present in the system
• RED • Initial bootup sequence, or a major alarm is present in the system
3 SYNTH
• GREEN • Locked
• RED • Unlocked
4 STATUS
• GREEN • No alarm for the SeRF II Module
• RED • Initial bootup sequence and should become GREEN within 1 minute; if RED after bootup, a
Major alarm exists for the SeRF II Module
5 POWER
• GREEN • Power OK and operating properly
• RED • Power supply out of tolerance
• OFF • No power present
SFP8
Tx
Rx
SFP7
Tx
Rx
LEDs for SFP in top port
1
2
3
4
5
LEDs for SFP in bottom port