User's Manual
Table Of Contents
- About This Manual
- Related Publications
- Admonishments
- General Safety Precautions
- STANDARDS CERTIFICATION
- List of Acronyms and Abbreviations
- 1 Description
- 2 UNPACKING AND INSPECTION
- 3 MOUNTING PROCEDURES
- 4 INSTALLATION PROCEDURES
- 5 Installing Remote Unit on the Mounting Bracket
- 6 Specifications
- 7 Power Consumption
- 8 Customer Information and Assistance
ADCP-75-347 • Issue 1 • 04/2008
Page 1
© 2008, ADC Telecommunications, Inc.
1 DESCRIPTION
The FlexWave URH Remote Unit interfaces with the Host Unit and performs the optical to
electrical conversions for transport to the antennas. A typical FlexWave URH system consists of
a Host Unit (HU) and a Remote Unit (RU).
The RU is comprised of three RF doors and one common door on a single chassis. The doors are
named left, right and front as viewed from the top of the chassis (Figure 1). The common door is
necessary for all deployments. For normal operating conditions the host DART RF matches the
remote. In simulcast mode the host DART RF matches the remote in the simulcast ratio.
Figure 1. RU Door Locations Top View
1.1 RF Spectrums
The following RF spectrums are supported:
Cellular 800 A
• TX: 869-880, 890-891.5 MHz
• RX: 824-835, 845-846.5 MHz
Cellular 800 B
• TX: 880-890, 891.5-894 MHz
• RX: 835-845, 846.5-849 MHz
MOUNTING BRACKET
COMMON (REAR) DOOR
FRONT DOOR
LEFT DOOR
RIGHT DOOR
22431-A