User's Manual
Table Of Contents
- About This Manual
- Related Publications
- Admonishments
- General Safety Precautions
- STANDARDS CERTIFICATION
- List of Acronyms and Abbreviations
- 1 Description
- 2 UNPACKING AND INSPECTION
- 3 MOUNTING PROCEDURES
- 4 INSTALLATION PROCEDURES
- 5 Installing Remote Unit on the Mounting Bracket
- 6 Specifications
- 7 Power Consumption
- 8 Customer Information and Assistance
ADCP-75-347 • Issue 1 • 04/2008
Page 21
© 2008, ADC Telecommunications, Inc.
6 SPECIFICATIONS
The specifications for the FlexWave URH Remote Unit are listed in Table 4.
Table 4. URH RU Specifications
PARAMETER SPECIFICATION REMARKS
Physical/Environmental/
Electrical
RU dimensions (H× W× D) 30.45 × 17.63 × 16.95 inches
(77.3 × 44.8 × 43.1 cm)
Mounting Pole/Wall
Weight 197 lbs (89.4 kg) With solar shields installed
Weather resistance IP.67 Indoor or outdoor installation
Operating temperature –40º to +50º C (–40º to +122º F) 10–90% Humidity non-condens-
ing
Storage temperature –40º to +85 C (–40º to +185º F)
RJ Sealed RJ-45 female connector
AC power connector Sealed 3-pin AC power
Antenna cable connector 50 ohm N-Type (female) 50 ohms input/output impedance
Lightning suppression (for
antenna cable connector)
20 kA IEC 1000-4-5 8/20 μs wave-
form
Provided by external lightning
surge suppressor (accessory)
Voltage input 100 to 240 VAC, 50 to 60 Hz Operating range 90 to 265 VAC
Power consumption See Table 5 and Table 6.
Current rating Calculate based on power consump-
tion and operating Voltage. See
Section 7.1 Power Calculation.
Maximum fuse size 20 Amps.