User's Manual
Table Of Contents
- About This Manual
- Related Publications
- Admonishments
- General Safety Precautions
- STANDARDS CERTIFICATION
- List of Acronyms and Abbreviations
- 1 Description
- 2 UNPACKING AND INSPECTION
- 3 MOUNTING PROCEDURES
- 4 INSTALLATION PROCEDURES
- 5 Installing Remote Unit on the Mounting Bracket
- 6 Specifications
- 7 Power Consumption
- 8 Customer Information and Assistance
ADCP-75-347 • Issue 1 • 04/2008
Page 9
© 2008, ADC Telecommunications, Inc.
4.1 Installation Overview
Installation of the RU consists of the following basic steps:
1. Connecting the fiber cables.
2. Connecting the antenna coaxial cables to the RU antenna ports.
3. Installing the AC power cable and connecting it to the RU power port.
4. Installing the shields.
4.1.1 Installation Hardware Provided with RU
The installation hardware that is provided with the RU is listed in Table 3.
4.1.2 Tools and Materials Required
The following tools are required in order to complete the procedures in this instruction:
• #6 metric socket key or 7/32-inch hex key wrench
• Wire cutters
• Wire stripper
• Compression pliers for splicing grounding cable
• Tools for installing exterior AC circuit
• Tool kit for attaching N-Type connectors to coaxial cable
The following materials are required in order to complete the installation procedures:
• #6 AWG (4 mm) copper wire and splice
• #10 ring terminal for attaching #6 grounding wire to bottom of unit
• Connector for attaching #6 grounding wire to approved earth ground source
• Junction box, conduit, fasteners, connectors, and wire to install an exterior AC circuit.
• N-Type male connectors
Note: To insure that all connectors and ports remain dust-free during installation, leave all
dust caps and dust protectors in place until directed to remove them.
Table 3. Remote Unit Installation Hardware
ITEM QUANTITY
AC Power Cable (15 feet/4.6m) 1
Quad Fiber Cables 1
Solar Shields 3
3/8-inch hex standoff 3
3/8-inch 10-32 phillips screw 3
#10 split washer 3