User Manual Part 3

Page 326 FlexWave Prism Host, Remote and EMS 5.1 System Reference

33 Remove from the front of the Host the blank panel that corresponds to the

selected slot location.

44 Do one of the following:

•• If you are installing a Dual SuperDART card:

aa Loosen the two retaining screws on the front of the blank panel and then

then remove the blank panel.

bb Use a Phillips screwdriver to remove the two screws from the divider bar,

and then remove the divider bar, storing the bar and screws for potential

future use.

•• If a Dual SuperDART card had previously been installed and you are now

installing a Single SuperDART or Classic DART, use two Phillips-head screws

to reinstall a divider bar.

Blank Panel with

2 Retaining Screws

Divider Bar with

2 Philips-Head Screws

77073-079