User Manual Part 3

Page 324 FlexWave Prism Host, Remote and EMS 5.1 System Reference

A.4.4 Install New SeRF Card

99 Slide replacement SeRF Card into the Host chassis until it is firmly seated.

100 Secure the SeRF Card to the front of the enclosure using the two thumb screws

loosened in Step 4.

111 If necessary, install new SFPs or remove them from the SeRF card removed in

Step 5 and install them in the new SeRF Card.

122 Plug fiber patch cords back into the SFPs, making sure that you return the fiber

patch cords to the position they were in prior to this procedure.

133 Plug Network and Craft RJ-45 plugs into the connector on the SeRF Card. Make

certain the fiber patch cords are inserted in the correct SFP.

144 Notify the NOC or alarm monitoring system operator that the system is back in

operation.

If you are going to swap the Compact Flash card from the old SeRF card to the new,

before starting th

is procedure, complete the steps in “Swap Compact Flash From Old

SeRF Card to New SeRF Card” on page 323.