User Manual Part 3

Page 322 FlexWave Prism Host, Remote and EMS 5.1 System Reference

A.4.2 Remove the SeRF Card

22 Remove Network and Craft RJ-45 plugs from the front of the SeRF Card.

33 Remove fiber patch cord from the SFPs. Note the location of the fiber patch cords.

44 Loosen the two thumb screws that secure the System Card to the front of the Host

enclosure.

55 Use the two handles to carefully withdraw the SeRF Card from the enclosure.

Electronic components can be damaged by static electrical discharge. To prevent ESD

damage, slip on a

n Electrostatic Discharge (ESD) wrist strap and connect the ground wire

to an earth ground source. We

ar the ESD wrist strap while completing each step in this

procedure.

This equipment uses a Class 1 Laser according to FDA/CDRH rules. Laser radiation can

seriously damage

the retina of the eye. Do not look into the ends of any optical fiber. Do

not look directly into the

optical transmitter of any unit or exposure to laser radiation

may result. An optical power meter sh

ould be used to verify active fibers. A protective

cap or hood MUST be immediately placed over any ra

diating transmitter or optical fiber

connector to avoid the potential of dangerous amounts of radiati

on exposure. This

practice also prevents dirt particles from entering the connector.

Improper handling can damage fiber optic cables. Do not bend fiber optic cable more

sharply than the

minimum recommended bend radius specified by the cable

manufacturer. Do not apply more pulling force

to the cable than specified.

22397-A

HANDLES