User Manual Part 2

Initial Prism System Setup

Page 164 FlexWave Prism Host, Remote and EMS 5.1 System Reference

377 Click

Apply

. The following example shows the completed link (in this case,

Host

DART SFP Id 8

has been selected).

388 Set the

LPA Operating Mode

normal

If multi fibers are connected between the Host and Remote, the system will try the fibers

in numerica

l sequence until a link can be established for the identified passband. If no

fiber is available prov

iding the number of TDM timeslots required for the passband, an

error message is returned indicating

that “DART linking failed due to a problem on the

host.”

If adding a link to an existing simulcast con

nection, the system requires the use of the

same timeslots. If the timeslots aren't available, the sy

stem returns the following error

message: “DART linking failed due to a problem on the host.”

As soon as you set the LPA Operating Mode to normal, RF transmission will start. Before

you set the L

PA Operating Mode to normal, make sure that the antenna has been

connected and the system is ready to

transmit RF. For information on connecting the

antenna, see

“Antenna Cable Installation” on page 123.