User Manual Part 2

Initial Prism System Setup

Page 162 FlexWave Prism Host, Remote and EMS 5.1 System Reference

6.9.3 Link a Remote DART to a Host DART

333 Verify that the Host DART is configured as described in “Configure the Host

DARTs” on page 152.

344 In the Function Explorer Tree, select

System View

Remotes

Remote#-

SERF

Groups

(where

Remote#

indicates the Remote number that corresponds to a Host

SFP port number and

n is the Remote name) to open the

Alarm Summary of RF Groups

view (see Figure 6-2 on page 161).

355 In the rectangle for the RF group selected, click on the

config

link for the band

being linked to open a

Configuration Details

window that corresponds to the

selected link.

The table at the bottom of the

Configuration Details

window indicates which Host

Unit DART is available for use in linking. In this example, the display indicates

that

Host DART ID 1

(top row, circled in red) is assigned to

DCS Full Band

This procedure requires that the antenna has been connected and the system is ready

to transmit RF. F

or information on connecting the antenna, see “Antenna Cable

Installation” on page 123.