User Manual Part 2

Configure the Host DARTs
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 153
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
255 In the
Configuration and Alarm Details of DART n
window that opens, set the
DART
Attributes
:
aa In the
DART Name
box, enter a name for the DART between 5 and 32 characters
with no spaces. The only special character allowed is an underscore, but it
cannot be the first character of the name. Numerals are allowed, but cannot be
the first character of the name.
bb In the
DART Pass Band (Timeslots)
list, select the DART Pass Band to be
supported by this DART. The list will include only those pass bands that are
valid selections for the DART band. For example, if the DART band is
“cellular,” only cell pass bands are listed.
cc In the
DART Operating Mode
list, select one of the following:
•
Standby
—forces the RF function to be muted in the Host and its linked
Remote.
•
Normal
—allows the system to operate normally (RF function not forced to
be muted), assuming all other system components are in proper working
order. (Default setting.)
The mode
Undefined
is not user selectable, and indicates that the EMS is
unaware of the current mode.
dd In the
DART Diversity Status
list, select
nonDiversity
or
diversity
. For a diversity
application, one DART will be configured
nonDiversity
for the primary
FWD/REV path signal and the other DART will be configured
Diversity
. This
selection therefore determines whether the DART card being configured will
carry the primary or secondary RF path.
a
b
c
d
e
f