User Manual Part 2

Enter a Host Name, Clock Source, and Linking Mode
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 149
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
133 Skip setting the
Network Interface
parameter—do not change this setting during
this procedure. Refer to “Changing to Built-In Network Mode” on page 186 for
information on setting the
Network Interface
.
144 In the
Linking Mode
list, keep the default setting of
Automated.
In Automated
Linking mode, the Host passes its
DART Pass Band
and
DART Diversity Status
to
connected Remotes. For a Multi-Host system, you must select
Manual
as this allows
you to manually set
DART Pass Band
and
DART Diversity Status
. If you are setting up
a Multi-Host system, leave the
Linking Mode
set to
Automated
, complete the initial
setup, and then complete “(Optional) Configuring Multi-Host Systems for Manual
Mode” on page 168.
155 Click
Apply
to save the
10 MHz Reference Clock
and
Linking Mode
changes.