User Manual Part 2

Install the Remote

FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 97

4.3 INSTALL THE REMOTE

This chapter guides you through installing a Prism Remote, which requires 63 steps

that are divided into 9 sections. Follow the steps in the order in which they are

provided.

4.3.1 Unpack and Inspect the Remote and Components

This section provides instructions for opening the shipping boxes, verifying that all

parts have been received, and verifying that no shipping damage has occurred. Use

the following procedure to unpack and inspect the Host and any accessories:

Unpack and inspect the various components as follows:

11 Inspect the exterior of the shipping container(s) for evidence of rough handling

that may have damaged the components in the container.

22 Unpack each container while carefully checking the contents for damage and

verify with the packing slip.

33 If damage is found or parts are missing, file a claim with the commercial carrier

and notify ADC Customer Service (see “Contacting ADC” on page 335). Save the

damaged cartons for inspection by the carrier.

44 Save all shipping containers for use if the equipment requires shipment at a

future date.

This is restricted access equipment and only service personnel should open and operate

this equipment

using appropriate tools

Wet conditions increase the potential for receiving an electrical shock when installing or

using elec

trically- powered equipment. To prevent electrical shock, never install or use

electrical equipment in

a wet location or during a lightning storm.

Installation of the Remote may proceed separately from the installation of the

corresponding Host.