User Manual Part 2

Installing the Remote Unit

Page 128 FlexWave Prism Host, Remote and EMS 5.1 System Reference

444 Remove the dust cap from the AC power port located on the bottom of the Remote

as shown below.

455 Connect the power cable connector to the AC power port.

466 Tighten coupling nut until the green band at the top of the connector body is

visible.

While trying to connect the AC power cable to the Remote AC power port, it is possible

for the line t

erminal on the cable connector to contact the ground pin on the power port.

If the AC cable is energi

zed, this will result in a direct short to ground for the AC power.

To avoid possible personal injury

and equipment damage, always turn the AC power off

before connecting the AC power cable to the AC po

wer port.

NETWORK

AUX.

MOD A

RX1

MOD A

TX0/RX0

FIBER 1

FIBER 2

MOD B

TX0/RX0

MOD B

RX1

MOD C

TX0/RX0

MOD D

TX0/RX0

MOD C

RX1

MOD D

RX1

POWER

100-240 VAC

50-60 Hz

16 AMPS

77073-015

Bottom View

Power

cable

Green band will be

visible when coupling —

Nut is tightened