User Manual Part 2

Install any 40W RF Module(s)
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 119
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
4.4.5 Network Cable Installation
The Remote provides a Network port allowing communications with the internal
processor and transfer of service data to the optical protocol allowing IP servicing
between the Host and Remote(s). That is, this provides a LAN extension to the Host
network. The Network port is 10/100/1000 BASE-T/TX (802.3ab compliant) MDI and
requires a minimum of CAT 5 cable.
The network cable must be terminated with a hardened RJ-45 male connector for
connection to the Network port. The maximum cable length is 300 feet (91.4 m).
Use the following procedure to install the Network cable:
177 Remove the dust cap from the RJ-45 connector located at the bottom of the
Remote.
188 Route the network cable from the network connection to the underside of the
Remote.
199 Align the plug end of the RJ-45 cable connector with the RJ-45 port receptacle and
then insert the cable plug into the port receptacle.
Although the interface might provide GigE, only 100 Mbps is provided for bandwidth
between the Host a
nd Remote.
NETWORK
AUX.
MOD A
RX1
MOD A
TX0/RX0
FIBER 1
FIBER 2
MOD B
TX0/RX0
MOD B
RX1
MOD C
TX0/RX0
MOD D
TX0/RX0
MOD C
RX1
MOD D
RX1
POWER
100-240 VAC
50-60 Hz
16 AMPS
RJ-45 Network
Connector port
Network cable
Connector nut
RJ-45 plug
Bottom View
77073-010