User Manual Part 2

Installing the Remote Unit
Page 116 FlexWave Prism Host, Remote and EMS 5.1 System Reference
© 2009 ADC Telecommunications, Inc ADCP-77-073 • Issue 2 • 11/2009
The following graphic shows cable connections for a dual-slot RF Module.
10 Ensure that all cable bends are below the top edge of the Connector Interface
Panel as indicated by the dashed line in the preceding figure. Failure to
correctly position the cables could inhibit closing the Remote door, which can
result in damage to the cables.
Cable connections
for a dual-slot RF Module
Tie wrap
Factory-installed
RX1 cable
77072-007