User Manual Part 2

Installing the Remote Unit
Page 112 FlexWave Prism Host, Remote and EMS 5.1 System Reference
© 2009 ADC Telecommunications, Inc ADCP-77-073 • Issue 2 • 11/2009
4 Push the left edge of the RF Module back and into the Remote chassis until it
can go no further.
Make sure the RF Module is seated correctly in the Module shelf. Incorrect alignment of the RF Module can
cause the RF Module to fail due to over heating.
• The front edge of the RF Module should be parallel with the shelf above it.
• The Mounting hook on the RF Module should be fully engaged with the Receiving flange on the Remote
chassis.
• If you later cannot shut the Remote door, verify that the RF Module is installed correctly.
77072-008
In Steps 9 and 10, you engaged the right side of the RF Module with the Remote chassis.
In Step 11, you set the left edge of the RF Module into the Remote chassis.
By the end of Step 11, the front edge of the RF Module should be parallel with the shelf above it.
Now in Step 12, you are pushing the RF Module back into the chassis until it can go no further.