User Manual Part 2

Installing the Remote Unit
Page 94 FlexWave Prism Host, Remote and EMS 5.1 System Reference
© 2009 ADC Telecommunications, Inc ADCP-77-073 • Issue 2 • 11/2009
4.1 REMOTE INSTALLATION OVERVIEW
Installation of the Remote consists of the following basic steps:
11 Unpack and inspect your shipment.
22 Install the RF module(s).
33 Connect the ProAx Fiber Cables.
44 Connect external coaxial antenna cables must be routed from the antenna to the
Remote TX0/RX0 and RX1 connectors.
55 Install the AC power cable and connect it the Remote’s AC power port and to an
external junction box .
4.1.1 Installation Hardware Provided with Remote
The installation hardware provided with the Remote is listed in Table 4-1.
To insure that all connectors and ports remain dust- free during installation, leave all
dust caps and
dust protectors in place until directed to remove them.
Table 4-1. Remote Unit Installation Hardware
Item Quantity
AC Power Cable (15 feet/4.6m) 1
Quad Fiber Cable Assembly 1
(a)
(a) If the Remote has more than 2 SFPs, two Quad
Fiber Cable Assemblies are required.
3/8-inch hex standoff 3
3/8-inch 10-32 phillips screw 3
#10 split washer 3