User Manual Part 2

Install the Remote
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 105
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
177 Ensure that all cable bends are below the top edge of the Connector Interface
Panel as indicated by the dashed line in the preceding figure. Failure to correctly
position the cables could inhibit closing the Remote door, which can result in
damage to the cables.
MOD A
MOD D
MOD C
MOD B
SeRF
Module
TX0/RX0
RX1
DIV
PRIM
PWR
77073-043
Note routing of
high-speed cables
Note bend
radii ≥ 1-inch
Edge of Connector Interface Panel