User Manual Part 2

Installing the Remote Unit
Page 102 FlexWave Prism Host, Remote and EMS 5.1 System Reference
© 2009 ADC Telecommunications, Inc ADCP-77-073 • Issue 2 • 11/2009
111 Push the left edge of the RF Module back and into the Remote chassis until it can
go no further.
Make sure the RF Module is seated correctly in the Module shelf. Incorrect alignment of
the RF Module
can cause the RF Module to fail due to over heating.
• The front edge of the RF Module should be parallel with the shelf above it.
• The Mounting hook on the RF Module should be fully engaged with the Receiving flange
on the Remote chassis.
• If you later cannot shut the Remote door, verify that the RF Module is installed
correctly.
77073-045