User Manual Part 1

Install the Host
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 85
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
655 Loop both power wires around and through the Ferrite as shown above. (The
Ferrite is required for FCC radiated-emissions compliance.)
666 Strip 0.5 inch (1.27 cm) of insulation from the end of each wire.
677 Insert one end of each wire into the terminal block, one into the positive (+) and
the other into the negative (–) position.
688 Insert the terminal block into the 3-pin receptacle on the front of the Host Power
Supply.
699 Install fuses in the fuse panel. Update office records as required.
When connecting the equipment to the supply circuit, check equipment nameplate
ratings to avoid overl
oading circuits which may cause damage to over- current
protection devices and supply wiring.
77073-070
Ferrite