User Manual Part 1

Installing the Host Unit
Page 80 FlexWave Prism Host, Remote and EMS 5.1 System Reference
© 2009 ADC Telecommunications, Inc ADCP-77-073 • Issue 2 • 11/2009
3.3.9 Computer Connection (Craft)
The SeRF front panel provides a Craft port that provides an Ethernet interface that
allows you to connect a computer to access the EMS.
511 Connect one end of an Ethernet cable (CAT5 or better, not provided by ADC) to
the Host Craft port as shown below.
522 Connect the free end of the cable to the computer’s port. Refer to the user manual
provided with the computer to locate and configure the specified port.
In the default configuration, the Craft port has a DHCP server that assigns an IP address
to the comp
uter that is connected. You should therefore have your network interface
configured for DHCP, or conf
igured with a static IP address in the same subnet, where
the default is 192.168.0.1/24.
77073-067
RJ-45
Connector
detail