User Manual Part 1

Install the Host
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 77
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
466 Clean each fiber patch cord connector and then insert the connector into the
appropriate optical port on the Host as shown below.
477 (Optional) If adding CWDM accessories, see the ADC FlexWave™ Prism Coarse
Wavelength Division Multiplexer User Manual (ADCP-75-353) for installation
information. (For an overview of a Prism CWDM system, see Section 1.2, Course
Wavelength Division Multiplexer System, on page 4).
The Host SeRF SFP optical adapters are angled to the left. Therefore, fiber patch cords
should always
be routed to the Host from the left side of the rack. Routing fiber patch
cords to the Host from the
right side of the rack may exceed the bend radius limitations
for the optical fiber.
77073-033
FWD path
REV path