User Manual Part 1

Install the Host
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 75
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
311 Route the patch cords from the Host to the fiber distribution panel.
322 At the fiber distribution panel, identify the OSP cable optical fiber terminations
that correspond to the forward and reverse paths.
333 Remove the dust caps from the OSP cable optical fiber adapters and from the
patch cord connectors.
344 Clean each patch cord connector (follow patch cord supplier’s recommendations)
and then mate the connector with the appropriate OSP cable adapter.
355 Repeat this procedure for the remaining SeRF SFPs in the Host.
366 Store any excess patch cord slack at the fiber distribution panel or storage panel.
The Host optical adapters are angled to the left. Therefore, always route patch cords to
the Host fro
m the left side of the rack. Routing patch cords to the Host from the right
may exceed the bend radiu
s limitations for the optical fiber.
77073-033
FWD path
REV path