User Manual Part 1

Install the Host
FlexWave Prism Host, Remote and EMS 5.1 System Reference Page 67
ADCP-77-073 • Issue 2 • 11/2009 © 2009 ADC Telecommunications, Inc.
Use the following procedure to install the Host in the equipment rack:
55 The Host is shipped with the mounting brackets installed for 19-inch rack
installations. If mounting the Host in a 19-inch rack, proceed to Step 6. If
mounting the Host in a 23-inch rack, proceed to Step 8.
66 Remove both mounting brackets from the Host (requires TORX screwdriver with
T20 bit) and save screws (six-screws on each side) for reuse.
77 Reinstall both mounting brackets so the long side of the bracket is flush with the
Host front panel as shown below. Use the screws removed in Step 6 to re-attach
the brackets to the Host chassis.
88 Position the Host in the designated mounting space in the rack (per system design
plan) and then secure (but do not tighten) the Host to the rack using the four
machine screws provided (use #12-24 or M6 x 10 screws, whichever is
appropriate).
99 Locate two vertical cable guides, not provided with the Host.
100 Back out the Host mounting screws just enough to provide clearance for
installation of the cable guides.
111 Slide each cable guide into position for installation and then securely tighten the
corresponding mounting screws.
A vertical cable guide kit is available separately as an accessory.
Install Mounting
Brackets as shown for
installation in 23-inch Racks
77073-060